Content Comparison

Prior to SMartServer 3.5, the alarms and events widget was called alarms.

...

1. Open the Alarms and Events widget. Click the Expand button ().

   Image Modified
   
   

2. Click the Action button () and select the Export Alarms action.
   
   
   
   The Alarms and Events view appears.
   
   
   
   

3. Set the report parameters:
   
   

   • Active Only – enable slider for active alarms or disable slider for all alarms
   • Period – specify the time period for the alarms report
   • Format – select PDF or CSV file format
     
     
     
     
4. Click EXPORT.
   
   An alarm report in CSV or PDF file format is stored to your computer and is shown in the following PDF example.
   
   

...

You can view active alarms in the Alarms and Events widget. Active refers to alarm conditions that are on-going. For example, if a high-error datapoint value alarm for a temperature datapoint is set for 100 degrees, and the current measured temperature is greater than 100 degrees, then the alarm is active. If the current measured temperature is less than 100 degrees, then the alarm is not active.

To view active alarms with SmartServer 3.5 or higher, follow these steps:

...

1. Open the Alarms and Events widget. Click the Expand button ().

   Image Modified
   
   

2. Click the checkmark(s) for the alarms to be cleared, or click the Select All button () to select all alarms.

   The checkmark(s) changes from blue to yellow.
   
   
   
   

3. Click the Action button () and select the Clear Selected Active Alarms action.
   
   
   
   A confirmation dialog box appears.
   
   
   
   
4. Click OK to clear the selected active alarm(s).

...