Viewing System Information (Release 3.4 to 4.1)

For SmartServer 4.2 and higher, see Viewing System Information.

For SmartServer 3.3 and prior, see Configure Your SmartServer (Release 3.3 and Prior)

The SmartServer Configuration page provide the ability to configure the SmartServer network and system settings, as well as LON, BACnet, OPC UA, RS-485, and IAP/MQ server (Features Configuration page). When you access the SmartServer Configuration page, the Network Configuration page appears with tabs at the top of the page for other configuration settings. From the System Configuration page, you can view SmartServer system information.

To view your SmartServer IoT system information, access the SmartServer System Configuration page and then click the System tab on the Network Configuration page.

The System Configuration page appears with the system information displayed at the top of the page. The system information includes the following:

  • Version
  • Serial Number
  • MACID
  • Install Code
  • Segment Provisioning Status
  • Segment ID
  • LON Network Management Mode (i.e., Device or Independent)
  • System Uptime

For more information about the settings and information available on the System Configuration page, including the SmartServer version, install code, the configured LON network management mode, see (Optional) Secure Your SmartServer.

For more information about switching the LON network management mode, see (Optional) Switch From LON Management.

For more information about changing passwords, see Managing Passwords in the (Optional) Secure Your SmartServer section.

For more information about rebooting the system, see Rebooting Your SmartServer IoT.

For more information about reseting the system to defaults, see Resetting the SmartServer IoT to Factory Defaults.

For more information about updating the system, see Updating or Re-imaging the SmartServer IoT.

For more information about downloading logs, see Downloading Logs. This feature is available with SmartServer 4.0 and higher.

For more information about HTTP proxy, see Configuring HTTP Proxy. This feature is available with SmartServer 4.0 and higher.

For more information about Remote CMS, see Local CMS vs. Remote CMS. This feature is available with SmartServer 3.6 Update 2 and higher.