/
KB1448 - Visio prompts to Insert Smart Card

KB1448 - Visio prompts to Insert Smart Card

 Problem

The Smard Card message is a Microsoft message raised on some laptops. It is not related to Izot CT. If you click Cancel, it will proceed with opening/creating a network.

 Solution

  1. To remove this message, you can follow these instructions:

    Start --> Run --> type gpedit.msc and press Enter.

    Navigate to:

    Computer Configuration\Administrative Templates\Windows Components\Smart Card

    Right-clickTurn on Smart Card Plug and Play serviceand click Edit.

    Then select Disabled.

     

    And also enable macros in Visio:

    1. Click theFiletab, and then clickOptions

    2. ClickTrust Center.

    3. ClickTrust Center Settings, and then clickMacro Settings.

    4. Select Enable All Macros, and then clickOK.

    Change the Macro Settings for Visio

 Related Products

  • IzoT CT

  • OpenLNS CT

  • LonMaker

Related content

KB1391 - IzoT CT Unable to exit design mode because control could not be created LmwActiveX1 Error Message
KB1391 - IzoT CT Unable to exit design mode because control could not be created LmwActiveX1 Error Message
More like this
KB1451 - IzoT CT displays a Cannot start IzoT CT or Cannot start LonMaker
KB1451 - IzoT CT displays a Cannot start IzoT CT or Cannot start LonMaker
More like this
KB1349 - Visio 2016 Trust Center Settings for IzoT CT
KB1349 - Visio 2016 Trust Center Settings for IzoT CT
More like this
KB1450 - Visio installation: The system cannot find the file specified
KB1450 - Visio installation: The system cannot find the file specified
More like this