| Info |
|---|
For SmartServer 3.4 and higher, see Configure Your SmartServer. |
...
| Info | ||
|---|---|---|
| ||
If you are using a LON U60 interface with a static IP address for eth0 or eth1, you must set the LAN Interface Gateway field as shown in the example below.
|
The SmartServer hostname is displayed in the Hostname field and can be updated as needed if you are using self-signed certificates (not if you are using built-in, signed certificates).
...
- Click the SmartServer IoT or other device on the Devices widget.
The device details appear.
Verify that the latitude and longitude settings are accurate for the location of your SmartServer or other device.
If so, click CANCEL to return to the Devices widget.
If not, click the Set Location button (
) and set the latitude and longitude values as appropriate for your system. You can set the SmartServer or other device location by using the latitude and longitude arrows (
), by entering values directly in the latitude and longitude fields, or by moving the SmartServer or other device location on the map (
).Note Note: To best view all of the information on this view, click the Expand button ( 
). 
Click SAVE to save your settings and return to the Devices widget.
Note title Changing the SmartServer timezone or location may cause the SmartServer to reboot If changing the SmartServer timezone or If changing your location results in a change to the SmartServer's (or other devices') local timezone, then the SAVE operation will cause the SmartServer/device to reboot after about a one minute delay. If a reboot occurs, a blue banner will appear at the top, right of the CMS dashboard (shown below). Allow 5-8 minutes for the process to complete before continuing to work.
...
- Click the SmartServer IoT or other device on the Devices widget.
The device details appear.
- Click the Clear Locations button (
).
The device location and timezone values are cleared and the device is unassigned from any context and removed from the map
Click SAVE to save your location setting changes, or set the location and timezone as appropriate for your system.
Note title Reboot to Occur If you clear your SmartServer's (or other devices') location, then the SAVE operation will cause the SmartServer/device to reboot after about a one minute delay. If a reboot occurs, a blue banner will appear at the top, right of the CMS dashboard (shown below). Allow 5-8 minutes for the process to complete before continuing to work.
...
- Open the CMS Settings widget.
- Click SMTP Settings.
The SMTP Settings view appears.
- Enter the SMTP settings, including:
- Host – hostname, 4-40 characters (required).
- Port – port value between 1 and 65536 (required).
- From – email address, 1-40 characters (required).
- User – username for your email account on the SMTP server, 1-40 characters (required).
- Password – password for your email account on the SMTP server (required). Click the Show Password button (
) to display the password.
- Set options, including:
– set to on if the SMTP server requires authentication.
– set to on if the SMTP server requires Transport Layer Security (TLS) connection.
- Click TEST to send a verification email from the SmartServer to the provided email address.
- Click SAVE to save SMTP settings.
...