Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.
SmartServer Pi is available with SmartServer 4.2 and higher.

This section describes how to connect to Raspberry Pi remotely using SSH. You will use the SSH console to install the SmartServer Pi software. To perform these instructions, the Raspberry Pi must be attached to a wired LAN network, with a PC that exists on the same LAN network. This section consists of the following:


Once SmartServer Pi is installed and you are logged in, you can open a terminal connection using the SmartServer Pi Configuration page Terminal tab (left-side) as shown below.

Image RemovedImage Added