Versions Compared

Old Version 1

changes.mady.by.user Nina Cardillo

Saved on

compared with

New Version 2

changes.mady.by.user Nina Cardillo

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Remote EnOcean interface is supported with SmartServer 4.3 and higher.


Info

For SmartServer Pi, see (Optional) Add a Remote EnOcean Interface for SmartServer Pi (Release 4.3).

...

To set up and use remote EnOcean interface with the SmartServer, follow these steps:

  1. Optionally add an EnOcean network interface as described on this page. 

  2. Enable remote mode on your SmartServer as described on this page. For SmartServer IoT 4.3, do not use the EnOcean Configuration page to enable remote mode; for this release, remote mode is configured manually as described on this page. If a local EnOcean radio is used, then you will also configure Local Antenna Tunnel settings using the SmartServer EnOcean Configuration page as described on this page.
     
  3. Download and modify, or create an EnOcean device interface (XIF) and device type definition as described on this page.

  4. Define datapoint properties for any datapoints to be monitored or logged as described in Setting Datapoint Properties.

  5. Define or discover devices as described in Site Provisioning. See the following section on this page for a step-by-step example:
  6. Optionally, provide a BACnet interface for your EnOcean device; see Setting up the BACnet Server.  This enables you to use a BACnet workstation with your EnOcean device.

...