...
SmartSupervisor is available with SmartServer 4.4 and higher.
You can connect your SmartServer to a Remote CMS SmartSupervisor to create a system with multiple SmartServers using a single Remote CMSSmartSupervisor. The Remote CMS SmartSupervisor and all SmartServers using it must be the same release number.
To connect to a Remote CMSSmartSupervisor, follow these steps:
Install and start the
...
SmartSupervisor as described in Set up the
...
...
Enable
...
SmartSupervisor on each SmartServer that you plan to use with the
...
SmartSupervisor as described in Enable the
...
Open a web browser and connect to the
...
SmartSupervisor by entering the
...
SmartSupervisor IP address in the URL as shown below:
Code Block https://
...
<SmartSupervisor
...
IP address>
...
/cms
...
For SmartServer 4.0 and higher, the port is 443 and is not required for the URL. For releases prior to SmartServer 4.0, the port is 8443.
...
The SmartSupervisor login page appears.
...
Enter
...
the SmartSupervisor login username and password.
Click LOGIN.
The
...
SmartSupervisor dashboard appears.
Click the Devices widget, SEGMENT CONTROLLER tab. Click the Expand button (
...
). 
You will see all of the SmartServers that are connected to the
...
SmartSupervisor.
Once you have completed the steps in Remote CMS SmartSupervisor Getting Started, continue with SmartServer Getting Started. See Updating the Remote CMSSmartSupervisor for an overview of the basic operations and maintenance routines, as well information about how to update the Remote CMSSmartSupervisor.