(Optional) Remotely Accessing the IAP/MQ Server

Owned by Nina Cardillo
Last updated: 28-Mar-2024
2 min read
WITH SMARTSERVER 4.1 AND PRIOR, THE FIREWALL TAB IS CALLED FEATURES.

For SmartServer 4.1 and prior, see (Optional) Remotely Accessing the IAP/MQ Server (Release 4.1 and Prior).

With SmartServer IoT 2.7 Update 1 and higher, the Features page is used to enable IAP/MQ server settings for remote access. To enable RNIs and IP-852 and and IP-70 routing features, go to (Optional) Add a LON Interface. 

With SmartServer IoT releases prior to 2.7 Update 1, this page is also used to enable RNIs and IP-852 and and IP-70 routing features. 

To set up remote access to the IAP/MQ server, use the checkboxes on the Firewall Configuration page to enable eth0 and eth1 interface ports 1883 and 8883 as described below. With SmartServer 4.1 and prior, the Firewall tab is called Features. 

  1. Open the SmartServer Configuration page as described in Accessing the SmartServer IoT Configuration Page. The Network tab appears as the default SmartServer Configuration page. Once the network settings are configured for the SmartServer system, then the System tab will appear as the default.


    SmartServer IoT Network tab


    SmartServer IoT System tab

  2. Click the Firewall tab. 


    SmartServer IoT Firewall tab
  3. Use the checkboxes to enable eth0 and eth1 interface ports 1883 and 8883.


    SmartServer IoT Firewall tab

  4. Click Update to save your changes.